Gutter Repairs in Metro Atlanta
Sagging, leaking and pulled-away gutters put back to work
A gutter that drips, sags or spills over usually has one specific cause. Aqua Pro Pressure Washing handles gutter repairs for homes and businesses in Gwinnett County and greater Metro Atlanta, with over 15 years of industry experience.
- Resecuring and repitching
- Seam, corner and end cap leaks
- Downspout repairs and replacements
Get Your Free Gutter Repairs Quote Today
Get Your Free Gutter Repairs Quote
Request your free quote online in about a minute, or call us.
What that drip, sag or stain usually means
Walk around the house during a steady rain if you can. Ten minutes with an umbrella will tell you more than a dry afternoon on a ladder.
- Water spilling over the front
- Often a clog, a low spot or a downspout that can't keep up. If the gutter is clear, the pitch is the next thing to check.
- Water running behind the gutter
- The gutter may have pulled away from the fascia, or rain may be getting in at the roof edge.
- Drips at corners and joints
- The sealant has likely cracked or let go. These joints take the most movement as metal heats and cools.
- Standing water days later
- That stretch is often flat or pitched the wrong way, though a clogged outlet can do the same. Rust and seam failures like to start right there.
- Peeling paint on the fascia
- The board has been getting wet again and again. If a screwdriver sinks into it, the repair goes beyond the gutter.
Why gutters sag and pull away from the house
Weight does most of the damage. A gutter packed with wet leaves and pine straw carries far more load than it was hung for, and every storm works the fasteners looser.
Many older homes have long spikes driven through the gutter into the fascia. As the wood swells and shrinks through our wet and dry spells, those spikes slowly back out. You can often spot the heads sticking out along the front lip.
Resecuring generally means replacing failed fasteners with hangers that grip sound wood. The board has to be solid for that to hold, so we check it before anything goes back up. If it has rotted, fascia board repair comes first.
Getting the pitch right so water reaches the downspout
Gutters look level from the street, but they shouldn't be. A common rule of thumb is at least a quarter inch of fall for every ten feet of run.
When a hanger lets go or the fascia shifts, the fall can flatten out or even reverse, and water sits in the low spot. Repitching resets the run so it drains again.
The front edge matters too. A gutter that tips back toward the house sends its overflow down the fascia instead of letting it fall clear.
Gutter leak repair: where the water gets out
Sealant only sticks to clean, dry metal. Smearing fresh caulk over old caulk is why so many patched seams are dripping again before long.
| Leak point | Common cause | Usual repair |
|---|---|---|
| Corner | Sealant cracked by heat and movement | Remove old sealant, dry the joint, reseal |
| Section joint | Joint pulled open by a sag | Resecure the run, then reseal |
| Downspout outlet | Worn seal or loose connection | Refit and seal the outlet |
| Pinhole in the trough | Rust where water has been sitting | Patch if small and the metal around it is sound |
Downspout repairs people tend to put off
A crushed elbow behind the shrubs can choke an entire run of gutter, and the damage is easy to miss from the driveway.
Check the joints on your own house. At each one, the upper piece should slide inside the lower one so water stays in the pipe. Put together backward, they can weep.
Then look at where the water lands. Georgia red clay takes in water slowly, so rain dumped beside the foundation tends to stay there. If a downspout feeds a buried pipe and water backs up at the joint, the blockage may be underground, and underground drain cleaning may be what it needs.
Whether to repair the gutter or plan for something bigger
Usually worth repairing
- Loose hangers on solid fascia
- A few failed seams or corners
- One low spot in an otherwise good run
- A dented or crushed downspout
Repair may not pay off
- Rust through along much of the run
- Seams patched over and over
- Long sections bent out of shape
- Gutters too small for the roof above
Proudly Serving Metro Atlanta & Surrounding Communities
Summer downpours and falling pine straw are hard on gutters all over this part of Georgia, so give us a call if your town is on this list.
Our service areas include
- Atlanta
- Dacula
- Lawrenceville
- Buford
- Suwanee
- Sugar Hill
- Duluth
- Lilburn
- Snellville
- Grayson
- Loganville
- Alpharetta
- Johns Creek
- Roswell
- Sandy Springs
- Dunwoody
- Brookhaven
- Chamblee
- Doraville
- Norcross
- Peachtree Corners
- Tucker
- Decatur
- Stone Mountain
- Stonecrest
- Lithonia
- Conyers
- Covington
- Monroe
- Marietta
- Smyrna
- Mableton
- and surrounding communities.
Don't see your city listed? Contact Aqua Pro Pressure Washing today to confirm availability and request a free estimate.
Common questions about gutter repair
Can a sagging gutter be fixed, or does it need to be replaced?
Most can be fixed by resecuring the run and correcting its pitch, as long as the metal is in fair shape and the fascia is solid.
Why is my gutter leaking at the corner?
Corners rely on sealant, and the metal moves as it heats and cools until the seal cracks. The old material has to come off before resealing.
Why does water pour over my gutter when it rains hard?
Common causes are a clog, a low spot, a blocked downspout or a roof valley sending more water than that stretch can catch.
Should gutters be cleaned before they are repaired?
Usually, yes. Packed debris adds weight and can hide loose hangers or open seams, so a clear gutter is easier to judge. We will explain what we find and quote any repair separately.
Get your gutters draining the right way again
Tell us where the water goes during a storm and which part of the house worries you most. We are licensed and insured, and the estimate is free.
Request your free quote today.