Exterior Wood and Trim Repairs in Metro Atlanta
Fascia and soffit repairs that start with the water problem
Soft fascia and sagging soffit do not get better on their own. Aqua Pro Pressure Washing handles exterior wood and trim repairs along the roofline, and we look for the water causing the damage before any new board goes up.
- Fascia and soffit repairs
- Water source checked first
- Free estimates
Get Your Free Exterior Wood & Trim Repairs Quote Today
Get Your Free Exterior Wood & Trim Repairs Quote
Request your free quote online in about a minute, or call us.
Aqua Pro has over 15 years of industry experience. We are licensed and insured, and we serve Gwinnett County along with the rest of Metro Atlanta.
One bad board, or something bigger
A soft spot at the roofline can go either way. On a low eave you can often get a fair idea yourself. Anything high is better left to someone with the right ladder.
Where you can reach the wood safely, press an awl or small screwdriver into it. Sound wood pushes back, and if you pry a little it lifts in a long splinter. Rotted wood lets the tip sink in and breaks off short, in crumbs.
Decay often runs farther along the grain than the paint shows, so keep probing in both directions until the wood feels firm.
Signs of trouble at your roofline and what causes them
- Paint peeling in sheets
- Paint that keeps letting go after a fresh coat usually has moisture pushing out from behind it.
- Gutter leaning away
- Fasteners need solid wood to bite. Once the fascia softens they loosen, and resecuring the gutter will not hold until the board is sound.
- Dark soffit stains
- Water is getting past the gutter or the roof edge above. Look straight up from the stain to find where it starts.
- Drooping soffit panels
- Plywood soffit comes apart in layers after it has been wet over and over, then sags between its supports.
- Round holes with sawdust
- A clean hole about as wide as a fingertip on the underside of trim usually means carpenter bees. Woodpeckers may follow, digging for the larvae.
Why fascia rots behind the gutter first
Fascia is the long board nailed across the ends of your rafters, and the gutter hangs on it. That puts it in one of the wettest spots on a house.
Rain rolling off the shingles can cling to the roof edge and run back behind the gutter, especially where drip edge flashing is missing or poorly lapped. The gutter hides that path, so the face of the board may look fine while the back is going soft.
Clogged gutters add to the trouble, since a full trough can spill over the back as easily as the front. Cut ends soak up that water fast, and humid Georgia summers give wet wood little chance to dry.
Check where a lower roof runs into a wall, too. Without a kickout flashing at the bottom of that joint, roof water can pour straight behind the trim.
What exterior wood and trim repairs generally involve
Find the water
We inspect the roof edge, gutters and joints first. A new board under an old leak will fail the same way the last one did.
Open up the damage
The gutter over the bad section usually has to come down. With the old wood off, the rafter tails, deck edge and soffit behind it can be checked.
Cut back to solid wood
A repair should end in firm material. Joints generally land over a rafter tail, and an angled joint sheds water better than a square one.
Seal the new wood
Cut ends and the back face take on water fastest, so they should be primed before the board goes up, where a brush can still reach them.
Rehang and review
The gutter goes back on solid wood with the right slope. Before we leave, the work area gets cleaned up and you hear what turned up. Further repairs are quoted separately.
Proudly Serving Metro Atlanta & Surrounding Communities
Long humid summers and heavy tree cover are hard on roofline wood throughout these communities, so a soft board is worth catching early.
Our service areas include
- Atlanta
- Dacula
- Lawrenceville
- Buford
- Suwanee
- Sugar Hill
- Duluth
- Lilburn
- Snellville
- Grayson
- Loganville
- Alpharetta
- Johns Creek
- Roswell
- Sandy Springs
- Dunwoody
- Brookhaven
- Chamblee
- Doraville
- Norcross
- Peachtree Corners
- Tucker
- Decatur
- Stone Mountain
- Stonecrest
- Lithonia
- Conyers
- Covington
- Monroe
- Marietta
- Smyrna
- Mableton
- and surrounding communities.
Don't see your city listed? Contact Aqua Pro Pressure Washing today to confirm availability and request a free estimate.
Questions about rotted fascia and soffit
Can rotted fascia be repaired, or does the whole board need replacing?
Often only the damaged section has to go, as long as the remaining wood is firm and the new piece can join over solid framing. When rot shows up in several places along a run, replacing the full length is usually the sounder repair.
Is dry rot really dry?
No, the name is misleading. Decay fungi need wood that stays damp, even if the board happens to be dry on the day you find it. That is why the moisture source has to be fixed along with the wood.
Can I use wood filler on rotted trim?
Filler can work on a small defect in otherwise sound wood. Packed into soft, decayed fascia, it tends to crack and let go as the board moves with the weather, and the rot keeps working underneath.
What if the rot has reached the rafters?
A long-running leak can reach the rafter tails or the edge of the roof deck, and nobody can say for sure until the old board is off. If we find that, we will show you and explain your options before going further.
Could damaged trim mean I have termites?
Soft, crumbly wood is usually decay. Mud tubes, or wood hollowed out in layers along the grain, can point to termites. If you see either one, have a licensed pest control company look before any wood is replaced.
Have that soft board looked at before the rot spreads
Tell us what you are seeing at the roofline and we will set up a free estimate.
Request your free quote today.